|
Fireplace and Mantel FAQ's
Some interesting and frequently
asked for information on fireplaces and mantels.
Venting
What is the difference between direct vent,
b vent, totally vented and ventless?
A wood-burning fireplace is totally vented.
For a complete explanation of these terms see our
Venting page.
Can I put a cabinet around direct vent, ventless or b-vent?
Cabinets are boxes that extend about 18" from
the wall. Mantels are wood frames that only extend about 4" - 6"
from the wall.
* B-vent cannot have a cabinet. A b-vent fireplace must be installed
in the wall, allowing all the piping to be hidden. You may then use
a mantel.
* Direct vents can have a cabinet if you vent piping out the back.
* Vent-free can have a cabinet.
Can I use vented gas logs in a stove? ...In a fireplace? ...In a
coal
burning fireplace?
Vented gas logs can only be used in a wood-burning fireplace. A
coal-burning fireplace is too shallow. Vented gas logs are not
recommended for a stove due to safety concerns.
I am remodeling my basement. Should I go with direct vent or
vent-free?
Direct vent will give you great looks and a good amount of heat with
little moisture. Vent-free will give you lots of heat and good looks
but the number one complaint about vent-free is it works too well,
or puts off too much heat. If the vent-free is sized correctly to
the room, you will not have a problem with heat or moisture.
What is a chase?
A wooden structure built around the vent pipe to protect it from the
weather and to keep the flue gases venting properly.
How energy efficient is direct vent compared to b-vent?
A b-vent fireplace is the least efficient venting option and can be
vented horizontally or vertically. Direct venting is the most
efficient; some are even "heater rated" and can be vented
horizontally, vertically or both.
Remote Controls
What does remote ready mean? Does it come with a remote?
Remote ready means that via the remote (wired or wireless) you can
turn the unit on and off which requires a millivolt valve that
creates millionths of volts of electricity to control the valve.
Remote ready units do not come with a remote because there are up to
20 different kinds of remotes.
Can I use my wired wall switch or thermostat with variable
high-lo logs or fireplace?
No. You have to use the remote that is designed for the high-lo
variable logs or fireplaces.
What is a high-lo valve?
Via the remote, you will be able to raise and lower the height of
the flame. The remotes are adjustable as either on off or
thermostatically controlled.
Should I buy a remote ready vented logs set?
No. Because you would have to always leave the damper completely
open which means you'd lose $.60 of every heating dollar you put
into the house. Therefore, when you want to turn it on, you have to
open the damper. So most people just turn it on when they are
opening the damper and find the remote unnecessary.
Should I buy a remote ready with vent-free gas logs?
Yes. We suggest that you get a thermostatically controlled remote so
that you can keep the room at a comfortable temperature and so you
can turn the unit on and off. The longest lasting valve and remote
are the units that vary the height of the flame.
Conversion Questions
Can I convert my vent-free natural gas product to another fuel?
No. By national code, you cannot convert any vent-free product.
Can I convert my vented propane gas logs to natural, or vice
versa?
Yes. You can convert natural to propane and propane to natural, but
in most cases, you need to buy a new valve. Your manufacturer can
provide conversion instructions.
Piping, Dampers & Flue Questions piping
How much can I close my damper with vented gas logs when in use?
You cannot close your damper at all with vented gas logs while they
are burning.
How can I seal my damper with vent-free gas logs?
We would recommend that you close the damper as tight as you can and
get a Lock-Top damper that seals at the top of the chimney.
With a direct vent insert, do I need to reline the chimney?
No, you do not have to reline to wood burning specifications, but
you must use the piping that is recommended by the manufacturer,
which fits into the existing chimney.
What are the different kinds of burner pans for vent-free gas
logs?
There is sheet metal, black pipe and stainless steel. The advantage
of the sheet metal is that it is less expensive. Black pipe is
heavier than sheet metal and costs a little more. The disadvantage
of both is that they can rust through because they have very little
rust protection. Stainless steel costs more, but will not corrode or
burn through and it will last a lifetime.
How high above the roof should a chimney extend?
The minimum clearance for wood or b-vent is 3 feet above anything
within 10 feet. For direct vent it is 18 inches above anything
within 10 feet.
With direct vent or wood burning, what kind of piping do I use?
You must use manufacturer-approved piping.
Can different piping be used if I can't find the original
manufacturer's?
No. If you use some else's piping and it creates a problem in your
house; i.e., a fire or smoke damage, no insurance company will cover
you. You will also void the warranty and inspectors will not approve
it.
If brick is cracked can I burn wood?
If the crack is bigger than the tip of a graphite pencil, we do not
recommend that you burn wood.
Terms
What is the difference between an insert and gas logs?
An insert is usually a large metal box that fits into the opening of
a
wood-burning fireplace to increase its efficiency and enhance its
look. Gas log sets are made to be hooked up to a gas line to
simulate the look of wood logs.
What is an insert?
Inserts are designed to enhance the operation and appearance of an
existing wood burning fireplace, whether masonry or factory-built.
Categorized primarily by the fuel burned for operation (natural gas,
propane, EPA certified wood, pellet and coal), a fireplace insert is
installed into an existing wood burning fireplace. Fireplace inserts
are made from cast iron or steel and have self-cleaning glass doors
that allow the dancing flames of the fire to be viewed while the
insulated doors remain closed, making the fire more efficient. Many
manufacturers also augment the operation of fireplace inserts by
offering state-of-the-art features such as fans and thermostatic
controls (depending on the fuel).
What is the difference between an insert and a fireplace?
An insert is designed to be placed into an existing masonry or
factory built fireplace.
A fireplace is either masonry (not zero clearance) or factory built
(zero
clearance) unit built for burning wood or gas.
What is zero clearance?
A zero clearance fireplace is a factory-built fireplace that is
constructed so that it can be placed, safely, close to combustible
material.
What is the difference between natural and propane gas?
Natural gas is a lighter gas and it takes twice as much of it to get
the
same BTU rating as propane gas. Liquid propane gas contains 2,500
BTU's per cubic foot, natural gas contains 1000 BTU's per cubic
foot. In addition, natural gas comes into your home through a
pipeline from a local supplier. Propane is stored in a tank.
What are the two kinds of gas logs?
The two kinds of logs are vented and vent-free. Within these two
types, there are three kinds of materials used to create the logs:
molded refractory cement, extruded ceramic clay and molded ceramic
fibers. In addition to the logs, each log set generally includes a
grate and a burner system.
Cement logs are best on vented units. Extruded logs are cheaper but
look like spaghetti. Molded ceramic are more realistic and are best
for vent-free.
Helpful articles and common questions regarding
fireplace mantels:
|
|
